balcony frameless glass balustrade

Glass balustrade datas:

Balcony frameless glass balustrade is using in balcony decoration, frameless balcony frameless glass balustrade is good appearance and durable,many customers are keen on it.

Glass fence classification

All-glass: That glass and glass without any connecting material between the glass block and the block should be installed between the installation of about 8mm gap, so as not to collide with each other between the glass blocks or due to temperature changes resulting in damage to the glass. Glass fixed by the upper handrail and the ground below through the connection with the glass to achieve.

Inlaid: This way is through the glass column on both sides of the installation, both sides of the column notches, or with three sides of the ground, or with the handrail on three sides slotted. The glass directly into the two or three notches, through the notch into the glass glue to be fixed. Regardless of the column material, stainless steel or brass, are first grooved on both sides of the pipe, required cutting smooth, no uneven or with burrs. If the use of wood (very few) is also better to take a slotted method or cutting nail wood, through the tape to be fixed.

Hanging: Hanging mainly refers to the weight of the glass hanging through the handrail set to withstand a form. No matter what armrests are used to set the stainless steel hanging card below the handrail, the number of clips The general glass fence installed by two or three each glass to consider. In order to maintain the glass after the installation of stability, under the glass or in the lower two sides also with the column or the ground to be fixed. Taken to stay in the ground groove, the glass into the slot, or in the column welding clip stuck to the glass, and later with glass glue into the slot or bayonet, in order to fix the glass.

Plywood type: through the column on the welded slot to the glass stuck. At least two or more than two metal slots are to be provided on the metal posts. After the slots and posts are soldered, they should be polished and polished with no hand marks or visual marks. All slots in one column must be on a vertical line, and all posts in each column must also be vertical and straight. The slot between each two posts should be on a vertical plane. Glass must be installed into the slot when clamping the glass, but should be properly controlled clamping force, the design shall not exceed the scope of the request, to avoid damage due to excessive clamping glass.